You can use SNMP to monitor a variety of system states. Here is a list of common object ID's
To configure SNMP, browse to Settings -> SNMP
- click the Enable button.
- Enter the System Name. This could be for instance the hostname of the SpamTitan appliance.
- In the System Contact field, type in the name and/or email address of the network administrator for the SpamTitan appliance.
- The System Location field may contain addition information such as the physical location of the appliance, an email address or pager number.
- Create a name for a group or community of administrators who can view SNMP data, and enter it in the Community Name field. You should use a community string which is used/known only at your site.
- To restrict access further, enter the hostname, IP address, or cidr address of those systems/networks that are allowed perform SNMP queries. Typically this will just be the IP address of your SNMP Management station. If no hostnames/addresses are specified then any system that provides the correct commmunity string may request the SNMP data.
Note: SpamTitan supports most SNMP v1/v2c and relevant Management Information Base II (MIBII) groups which can provide a variety of information about your SpamTitan appliance. In addition the following OIDs provide information on the size of the mail queues:
- .184.108.40.206.4.1.2021.8.1.101.1 - Active Queue
- .220.127.116.11.4.1.2021.8.1.101.2 - Incoming Queue
- .18.104.22.168.4.1.2021.8.1.101.3 - Deferred Queue
- .22.214.171.124.4.1.2021.8.1.101.4 - Corrupt Queue
- .126.96.36.199.4.1.2021.8.1.101.5 - Hold Queue